Control Panels
Designed on "Modular Cubical" system, it has the facility of extensions or reductions as per requirements. Each modular cubicle is provided with swprate base channel to strengthen the cubicle and also enables easy movement, positioning and facility of grouting etc. Separate removable gland plates duly gasketed are provided for cable entry from tom or bottom, which can be removed and refitted. The design gives lot of flexibility for easy maintenance and interchangeability and cuts time loss during maintenance.

Bus-Bars
The Bus-Bar section is specially designed to accommodate adequate size of Bus Bars to match the current capacity, and are totally sealed to aviod any human error. The Bus-Bars are mounted on epoxy moulded type bus-bar insulators with adequate insulation safety factor.

The Air Gap is totally eliminated by fish plates and then bolted. adequate gap is maintained between each phases. The bus bar are insulated with heat shrinkable sleeves of adequate insulation. All outgoing bus bars are supported by epoxy insulators of adequate size to support and sustain the weight of outgoing cables/short circuit conditions with anti tracking facility. All incoming bus bars are covered with MS sheet to avoid any human contact. The Bus Bars material used is aluminium of Electorlytic grade.

Special Features

›› Door Hinges & Knobs
The Doors are specially designed to provide total sealing. The door hinges are designed to accomodate the doors on easily removeable and replaceable pins with soft rubber gaskets for complete dust proff sealing.

The door knobs are elegantly designed and fitted with spring loaded lock pin and can be operated by touch of the finger only.

›› Wiring & Termination
Different type of harnesses are being used for various starters and meter wiring etc. as per IS-8623 standards. All components/instruments in the panel are levelled with proper marking which enable even a layman to repair the equipments. The standard harnesses enable easy inter-changeability of feeders. 1.5 sqmm Copper Flexible wire is used for control wiring, 2.5 sqmm for CT wiring and minimum 4 sqmm Copper Flexible wire is used for power wiring. All cable ends are thimbled and starters are wired upto ready to use termination point.

›› Bus-Bars Heat Dissipation
The heat generated by the Bus-Bars due to different working conditions is normalized in the panels through louvers, cutout, which are provided at the required places. They allow the heat to escape, which increases the life of the electrical components. All the louvers are adequately closed with wire mesh to avoid entry of insects etc.


›› Accessories
All accessories used are of standard companies and have been selected after vigorous scrutiny. They meet all the required quality standards ensuring long life performance.

›› Testing
Testing facilities available:
1. High Voltage Testing Set.
2. Meggar Test.
3. Conductivity Test.
4. Continuity Test/Multimeter.
5. Phase Sequence Test.